In males with delayed puberty: Various dosage regimens have been used; some call for lower dosages initially with gradual increases as puberty progresses, with or without a decrease to maintenance levels. Other regimens call for higher dosage to induce pubertal changes and lower dosage for maintenance after puberty. The chronological and skeletal ages must be taken into consideration, both in determining the initial dose and in adjusting the dose. Dosage is within the range of 50 to 200 mg every 2 to 4 weeks for a limited duration, for example, 4 to 6 months. X-rays should be taken at appropriate intervals to determine the amount of bone maturation and skeletal development (see INDICATIONS AND USAGE and WARNINGS ).
Equipoise is not an ideal steroid for the drug tested athlete however. This drug has the tendency to produce detectable metabolites in the urine months after use, a worry most commonly associated with Deca-Durabolin. This is of course due to the high oil solubility of long chain esterified injectable steroids, a property which enables the drug to remain deposited in fatty tissues for extended periods of time. While this will reliably slow the release of steroid into the blood stream, it also allows small residual amounts to remain present in the body far after the initial injection. The release of stubborn stores of hormone would no doubt also be enhanced around contest time, a period when the athlete drastically attempts to mobilize unwanted body fat. If enough were used in the off-season, the athlete may actually fail a drug screen for boldenone although many months may have past since the drug was last injected.
One thing that you notice about trenbolone is that it is often a golden-brown / rust colour when in oil solution. If the hormone powder is refined to greater than % purity or so, then the colour of trenbolone in solution actually gives a very light golden colour, much like other testosterone products; however, refining the hormone to this level of purity is extremely difficult. This is why there is colour variation from batch to batch with different underground labs; something as small as % purity can affect the colour of the final product.